Fits in factory location on 2005-2010 Mustang GT
Does not include calibration, CALIBRATION REQUIRED, sold for tuner use
Twin 62mm bore (stock Mustang GT is twin 55mm)
CFM Rating: 1306cfm (stock dual 55mm throttle body: 953cfm)*
Precision machined from billet aluminum to ensure consistency
Polished finish with CNC'd Ford Racing logo
Fully assembled complete with throttle position sensor and actuator motor, ready to bolt on!
Uses OE gears to prevent gear bind and wear common with other aftermarket throttle bodies
Electronic throttle control was introduced on the Mustang in 2005. It's introduction has made attention to detail and setup of replacement throttle bodies even more critical than in the past.
Works well with Ford Racing''s M-6550-3V hot rod camshafts, M-6049-N3VPA high performance CNC ported 3V Cylinder Heads and Ford Racing's M-9424-463V performance intake manifold. Calibration Required.
All Ford Racing ETC throttle bodies feature:
All factory sensors installed - no need to tear apart your original throttle body
Calibrated for idle air flow using the same procedure as production throttle bodies
Precision billet construction with tapered inlet for consistent high flow
Polished aluminum for great looks and underhood "bling"
Throttle body features CNC'd Ford Racing logo
Validation through hundreds of hours of dyno, racing, and street performance driving
*All cfm ratings are calibrated at 28-inches of water, measured on SuperFlow SF-1020 Flow Bench